The Cloupor Mini 30 watt variable voltage mod is the perfect introductory step up into intermediate and advanced vaping. The Cloupor Mini utilizes a 510 threading with an adjustable pin for the atomizer, which is a perfect fit for a sub-ohm RDA or RBA such as the Atlantis by Aspire. This mod has an operating range of 7w – 30w and has a resistance limit of 0.45Ω – 3.0Ω, and has a resistance display that reads to the hundredth decimal (0.01Ω) place. The Mini is programmed for variable wattage as well as variable voltage, which can be selected by pressing and holding the “FIRE” and “DOWN” buttons for 5 seconds. Another cool feature is the LEFT/RIGHT modes, which rotates the digital display 180 degrees to better suit the user’s preference. The Cloupor Mini is powered by a removable 18-650 battery and even has reverse protection in the event the battery is loaded improperly. The Mini uses a Micro USB pass-thru port for charging, as well as connecting to your computer in the event firmware updates are released.
The Cloupor Mini is certainly very mini. At 77.5mm x 36mm x 22mm (3” x 1.4” x 0.8”), it is just marginally large than a Zippo lighter and very lightweight, yet sturdy, and has a magnetic battery door for a sleek look and ease of use. It will accommodate all 510-threaded atomizers and has no issues chasing clouds with an RDA. Because it is a variable voltage / variable wattage device, it has an onboard chip to detect any irregularities within the system. If the device does not detect an atomizer, or senses a resistance outside the limits, it will display CHECK ATOMIZER. The error LOW RESISTOR may also be displayed in the same situation. If the user is vaping with an RDA and has a build lower than 0.2Ω, the device will display a SHORTED error message. The Cloupor Mini also has an internal temperature sensor and will display TOO HOT when the board reads over 60-degrees Celsius (140-degrees Fahrenheit). Cloupor honors and includes a 90-day manufacturer’s warranty against defects with their Mini 30-watt mod. Included in the box, along with the mod itself, is a Micro-USB charging cable, a micro-screwdriver for pin adjustments, 3 extra pins for atomizer connections, 4 mini magnets for battery door replacement, a user manual, 90-day manufacturer warranty, and soft carry pouch. It is a very user friendly mod and has a very mellow learning curve, with only 3 buttons, an easy to read LCD screen, and informative error messages, it would make a great addition to any vaper’s kit at an affordable price.